Odyssey-electronics Marine GPS System User Manual download pdf (Page 10)

3.1.2 Power Cord Installation

Remove the power cord from the Odyssey Navigator package and plug

the power cord into the appropriate receptacle on the back of the laser

cradle. See Fig 3.1.2 Plug the power cord into a 110 Volt AC outlet

rated at 60Hz. Use only the power supply that comes with the device.

Use of other power supplies may damage the device or cause electrical

shock.

3.1.3 Direct Power Supply

If immediate power is needed and the battery is not charged, unplug the power cord from the cradle, Fig. 3.1.3a,

and plug it directly into the laser, Fig. 3.1.3b and 3.1.1c.

T h e L e a d e r i n D i o d e L a s e r s .

LASER ASSEMBLY INSTRUCTIONS

Section 3

Fig 3.1.2

Fig 3.1.3a Fig 3.1.3b Fig 3.1.3c

NOTE: To prevent power surges due to electrical storms or spikes in line voltage,

you should use a power strip with a circuit breaker or unplug the laser when you

are not present.

NOTE: The battery will be charged if the cable is plugged directly into the laser.

The laser can be switched on or off for the battery to be charged.

NOTE: DO NOT leave the AC cord attached to the laser or cradle when the power

supply is unplugged from the wall as this might inadvertently drain the battery.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

No comments

Odyssey-electronics Marine GPS System User Manual Page 10